Hellooooo once again, so all of the pcb boards are assembled and looking good! Also my wii is already prepared as I purchased it from crazygadgetmods on Etsy.
I am about to start wiring everything together, I will be using the diagrams on 4layertech's website to guide me. ---My question is, are the diagrams provided on their website going to show me everything I need?
Also I have not been able to find much help on how to wire up the screen driver board. So I have a couple questions with it
1. I assume I need to remove the circled components right? (attached photo)
2. Where do I wire those pads to?
3. It mentions on 4layertech - "modded to power on 3.3v by removing an inductor and wiring 3.3v and ground." I see what it is talking about, but I don't know where to wire 3.3v and ground. (other attached photo)
Thank you again (stiches most likely). You gotta let me know if I start to annoy you with these questions lol I swear I am doing reaserch there is just so much to know.
The diagrams I am referring to -
https://4layertech.com/products/ashida-pcb-set