Search results

Up

What do you think about this? it works well and is VALID...

So based on the voltage I recovered the value of the resistance that can be put Now there is another problem though only some resistances give the voltage with resistances under the value of 1K does not give any output voltage If I do not put any resistance the value of the output voltage is...

With this solution to find the right voltage and relative resistance value is a snap I was losing entire days without a REAL solution A question arises spontaneously By adjusting to 1V in output I get 400 OHM as resistance value compared to the approximately 800 recommended We are almost...

Then we are approaching the correct value of the resistance to reach 3.3V This morning I put a 3.3K + 510 ohm resistor (3.810) the voltage is 3.40 V (too much?) I have the possibility of trying with a 470 ohm instead of the 510 ohm one in order to have 3,770 Otherwise I have 330 ohm ones but I...

Today I put 4K and it gives me 3.42V probably 3.8 should give me 3.3V

Hi, I've received the resistors but I'm having difficulty finding the correct voltage These are my tests 2K 2.2V 3.3K 3.0V 4.7K 3.9V 4.4L (2.2+2.2 in series) always 3.9V what do I have to put on the mini 560 to get 3.3 V??? If you could kindly give me the list of resistors you put in to get the...

I understand that when you enter the data on PCBWAY, if you choose the resin, a message comes out that could cause deformations if you choose for example pla you will not receive this alert

Sorry, I didn't understand the question You wanted to know if the voltages were okay You have already changed the regulators and the resistors as I can see from the photos I'm also making the modification to the mini 560 regulators I think the voltages are fine, I think they're within 5% of the...

1V 75K 1.15 V 30K 3.3 V 2K 5V 360 OHM

I was afraid of an answer like that unfortunately Shipping costs more than the print However, I keep it in consideration thanks for the reply anyway

I live in Italy, how much would the print cost me including shipping? CAP 31022 Treviso(VENETO) ITALY Where do you live ?

I live in Italy, how much would the print cost me including shipping? CAP 31022 Treviso(VENETO) ITALY Where do you live ?

I'm looking for someone who can print or get me an Ashida case for my build

I had to put the motherboard to GND The USB port being detached from the motherboard was not grounded It was enough to connect the USB port to the ground of the motherboard and connect the ground wire coming from the power supply to the motherboard and it worked immediately by loading the RV...

I've tried them all but nothing has changed Even if I put the negative GND connected to the USB power supply it doesn't work and it doesn't detect the USB stick I also tried with the twisted enamelled cable and nothing changed