Search results

Amazing build! It looks really clean

Now this is epic B| I’m gonna need one of these, very nice work

Oh my, first I want to apologize to anyone who has made one yet… I original put the required chip as (SN74HCS11QPWRQ) but the correct required chip is 2 (SN74HCS7002QPWRQ1) I have updated this in the post and again, my bad for putting the wrong chip. I must have got them swapped when I...

Amazing build! Very clean case B|

I used the squishy tact buttons, they used to be orange, now I think some blue ones exist

My bad, lol never realized that

This is so clean! Excellent job! I love the L button addition :D

Notice: I would not use this for the N64HH build, that specific driver board will be released separate from this. This is the release of my Custom PCB that allows you to use simple Button Combinations to control the display and volume of your portable! Pinout: S1- Selector Button 1 (Volume...

This is the start of my worklog for my Wii portable! I found an old design I made 3 years ago in my closet, so I remade it and am working hard to finish it! It is based of JacksonS's Wii SP 2.0 a while back. I have gotten a lot better at making custom PCBS, so I hope to keep it clean and easy...

The paint coat looks sick! Excellent build!:D

I started working on this portable again after finding it in my closet. Been designing custom PCBS, heavy Fusion work, and more determination!

I used the FPC for power button, audio, Z and R buttons, controller board data, a couple for ground and for 3.3v I twisted two magnet wires, one ground, one video out, for the video. Running video through the FPC gave me interference on the display.

This is very impressive, excellent work! I’ll be ordering my own soon!

Just added them in! Also added a work in progress Google sheet of the BOM

Man this is so clean! Excellent frankencase work!

Hey guys I have 4 batches of JLCPCB ENIG gold plated PCBs for my N64HH V2 design, send me a dm if interested in purchasing a batch (1 of each board, so 3 total). I would charge $20 for 1 batch, All are sold!

That looks sick! This is the board I used, had to use a Dremel to cut a little bit off the front of the pcb to make the usb c protrude enough. https://a.aliexpress.com/_mLv3ZSk

Yes it is closed source, but I bought mine from CrazyGadget, he may be willing to sell more

That looks very clean, but V2 does have different screw posts at the top part of the front, so your print won’t work with the V2 back. V2 is out on the cutting edge section! It is the final design, as far as I can see.

The N64HH Rev2! Improved and better than ever! Improved the trigger design, used FFC cable to make wire routing simpler, custom made PCBs, and passive cooling setup! Uses Advanced Trim N64 motherboard with direct RCP wiring 5 inch 4:3 screen Gman’s RVL-PMS (could use another with modification...