Search results

As far as I know there is no Pin24 equivalent on the mainboard or cartridge slot and if it would probably also be connected with 23. Also puzzled me at first but 23 and 24 are basically the same.

Ok, meanwhile I did quite some debugging and got at least my second untrimmed Board running with PIF relocation and PMS. I fear that my trimmed board has been fried though, I guess I caused a short on the 3v3 rail at some point and killed a chip. Question is how to find out which component is...

Hi community, I am currently trying to get my trimmed N64 to work, but I have a hard time with it. After I didn't get my trimmed board to boot (just blue screen, no signal at all), I went back to a non trimmed mainboard and just tried to get it running using my PMS board + batteries, which...

Sorry that was kinda stupid of me. Advanced trimming guide pointed me to the Composite output at the ENC-NUS, not at the VDC. Now it works! But following up my question above, is composite the only option for the lcd? Would RGB be potentially better quality?

Hi all, I am trying to test a 4:3 lcd for my N64HH project, but I have difficulties to figure out how to connect it with my VDC-NUS. I've seen images of AVDC and MAV-NUS which apparently have a video out, but I have a VDC, which seems to be different? That's a schematic I found for all the...

I‘ll add a detailed BOM with links in the coming weeks. I am currently still waiting for some orders to confirm all parts are correct and necessary. The case is the one from the N64HH build by @Nicolas298. You can find his worklog including a dropbox with the files here. I ordered a 3d print at...

After months of planning, collecting information, asking stupid questions and ordering shiploads of stuff from China and US, I'm finally on my way to built my first N64 Portable. To satisfy my slight OCD I am trying to make it as clean as possible, which means I will try to take benefit of a lot...

Thank you very much for your answer. Just for the future, how do I know that I need 16V rated caps?

Hi all, I am trying to get all necessary parts to build an N64 Controller PCB by @Gman (this one). There is a BOM in the project but I am not sure which parts I should order. 1-5 - I think these are the easiest ones. I found caps / resistors with matching footprint and values, I am just not...

Thank you two gentlemen for the very helpful answers! I am slowly putting together all the things I need, and also ordered two NTSC mainboards from Japan (NUS-CPU-03 according to pictures) to get started. @CrazyGadget @Teatimetim I'd like to come back to your offer regarding boards and parts...

Thanks a lot for the warm welcome and your helpful answers! I started to make a first draft of a BOM and would very much appreciate a sanity check on the items. I collected the parts from all the different worklogs and threads, but maybe some things are redundant or not useful, or I just forgot...

Hi all, first of all thanks to @CrazyGadget that directed me to this forum and the discord! I am planning to build an N64HHv2 and have dug myself through various threads and worklogs with different build variations. I started to create a first BOM to get myself sorted but I still have a lot...

Hello BitBuilders! I am usually modding Nintendo handhelds (DMG, GBC, GBA, ...) but I'd like to go a step further and create an N64 portable, probably N64HHv2. How would I be able to post a thread in the beginners section? Still telling me I am not privileged enough (story of my life) :)