Search results

  1. PurpleSkyz

    Question Ashida audio issues

    Hi! I think it must be the picture but in reality there is good connection on those. Q
  2. PurpleSkyz

    Question Ashida audio issues

    I did yes, and I prepped them with solder before soldering them to the flex. Could it be the U-Amp itself? Q
  3. PurpleSkyz

    Question Ashida audio issues

    Hi Stitches, Sure here they are (also included GC2 +): Q
  4. PurpleSkyz

    Question Ashida audio issues

    Hi! My system doesn't reset when I plug in the headphones so it sounds like a different issue. I would recommend posting a new thread? Q.
  5. PurpleSkyz

    Question Ashida audio issues

    Hi everyone, So I just finished an Ashida build, but am experiencing strange audio issues. I use U Amp Initially I had no audio, but later on it magically appeared. Then it started dropping out intermittently every few seconds, but a lot more prominently when using the potentiometer, and the...
  6. PurpleSkyz

    Question Wii Trim board damage

    Thank you, much appreciated. Q
  7. PurpleSkyz

    Question Wii Trim board damage

    Hi everyone, I am in the process of building an Ashida, but during the Wii trimming process, I slipped and scrapped the top of the motherboard. I attached a couple pictures. I am fairly certain and hopeful that everything should be OK but would like confirmation before I invest more time with...
  8. PurpleSkyz

    PS2 Ultra Slim

    Sorry for my late reply! I tried yet another SD card and this one worked fine, so it turned out it is very particular about which SD card to use Q.
  9. PurpleSkyz

    PS2 Ultra Slim

    Question 1) I know this a stupid, but just in case, did you turn on the switch?... Question 2) Mine isn't detected either until I take the sd card out and put it back in while it's in the OPL menu, did you try that (with the switch on) Question 3) OPL configured correctly? BDM set to auto and...
  10. PurpleSkyz

    PS2 Ultra Slim

    Hi! All my PS2s are also chipped. This one is using Modbo 5.0 (but same issue using FMCB) OPL 1.2 for MX4IO support Ack and Ground is bridged. The issue may be that I didn't use the resistance? I read all sorts of conflicting guides saying that it is not necessary, but then why include it...
  11. PurpleSkyz

    BitBuilt Welcome Thread!

    Hi there, been building and modding now quite a few consoles and thought I would join this community of excellent people who have given so much to enable us to entertain and make possible all these builds. Q.
  12. PurpleSkyz

    PS2 Ultra Slim

    Question regarding this build. It seems that after every boot, I have to remove and reinsert the SD card for OPL to load the game list. Are there ways around this? Is it because I omitted to use a 50ohm resistance? Or could it be the 128gb Amazon SD card? (FYI, a Samsung Evo 1TB would freeze and...
  13. PurpleSkyz

    PS2 Ultra Slim

    I made an account because I want to clear this erroneous information that I have read in this thread multiple times and in other places. I just finished an Ultra Slim build with a PAL 79003 and it was completely fine (even the lid switch was where it should have been) Q.
Top