Search results

Pretty sure he used the same for the power, at least from the looks of it. They are very short cable runs after all.

Finished my initial build. I do still want to add the SD card reader and the HDMI output, but that can wait a little while longer. In the meantime I did something a little different and since my board didn't have the lid switch in the back and I needed a new switch anyways, I put it up front...

I totally missed that! thank you! I removed the cap/resistor or whatever it was, time to cut!

How did you cut this board, I have the same one and there is a small cap or other little electical device right in line of where you cut the USB port off on the back side. Is it ok to remove that small little piece the cut the usb part of board off?