Search results

I just realized that thank you

Unfortunately, when you buy the screen from 4 layer it also comes with the driver board. I only need the screen and don't want to end up with a second board

As I was putting the screen in place the shell that I printed and panted was just a little bit too small and cracked the screen. I was wondering if I could just buy the screen again and not the other components for it.

I got my Wii trimmed and cleaned up the edges of it. Then I tried to test it to see if I did it right but I was not able to get a video signal to show up. Also when I did test it I had the batteries for the Ashida build hooked up to it in the right spots, Plz help.

When I was cutting the Wii a dremel it slipped a few times on to the part of the Wii that I needed. I think that I missed all of the important stuff but just want a second opinion.

All of the parts for this build that are from Digikey are available except for the fan, part number: 1053-1684-ND. I was wondering if there is a different one that I could get for the build. I was also wondering what led to get for this build since it's not listed in the BOM.