Search results

What do I do? Customer support? Or can I fix it somehow? (well, with my knowledge probably not)

I measured the PMS Lite, everything seemed fine, however, the 1.8v outled said 3.56, pretty much the voltage of the batteries. Is this a problem? edit: it also puts out this voltage before I bridge the button with a ground.

How do I test the pms output leads? I already tested this https://bitbuilt.net/forums/index.php?threads/wii-trim-resistances.2602/ but this isn't the same?

Yes, I did

I tried it like this: but I still get nothing.

So, I wanted to test my trimmed wii. In order to do so I wired up my wii to the pms lite according to the documents om https://4layertech.com/products/pms2-lite I've left out the fan, sd-card reader and the light. I've added the av-cable and connector according to the ginger of vods video...

So, basically: batteries in Switzerland are expensive, and I wanted to maybe save on them. The alternative I found are INR21700-48G instead of the INR21700 50EI. The only difference that I could spot being the capacity. (4800mAh instead of 5000) It would cost 28.- instead of 66.- Is this a...

So, I've cleaned it with a toothbrush and then alcohol next, and tested the resistances. The resistances are just a bit lower than what they should be. Is this bad?

So, when I was trimming my Wii, I accidentaly slipped with my Dremel and scratched my Wii up a little there. Is this bad? Can I still fix it?

Hello, new to modding and would like to start making an ashida :)