Search results

Finally finished my fist GBoy. Found out it's a lot harder than it looks. Thank you to all that answered my noob questions. Now to move on to my own custom design!

When soldering to the vias, does it matter which i use? I know it shows both in the guide. Just wondering because I get the error you receive after installing bbloader, and you boot with SD card in, instead of USB.

Can someone look at this and see where I might off went wrong?

Bought a partially built gboy kit. The RVL pms 3v3 is not working. What should I check on the board? It was working then stopped. Nothing smoked or anything. Just stopped putting 3v3 out.

This is the start of my Largeii Wii build. Figured i would post a worklog thread of the build progress. Beginning of the design (WIP) My work area and motherboard trim. The build will use a large 7inch IPS screen, wii motherboard, switch joysticks, fullsize buttons and dpad.