Hello,
I am ordering parts to build Shank's RVL-129x BVM card. Following his BOM, I was able to find most of the parts but a couple were unavailable. I don't really know what each of the parts purpose is, and I'm pretty unfamiliar with micro component specs. So I thought I would ask here if the replacements I found are acceptable.
The first one is the 3.5mm audio jack. The BOM doesn't have a link, just a part number SJ-3524-SMT-TR. I found this part on Mouser and it looks the same to me.
The second part is this 2.2uf ceramic capacitor, part number VJ0805V225MXJTW1BC. Here is the link from the BOM:
The replacement I found has a few different specs, including dielectric & tolerance. I have no idea if these are relevant or important for my use case. I think they are the same size but the original part only specifies width, not height & length.
Everything else was in stock and available. Total order is currently ~$70 with shipping. The most expensive parts being the DIN connector, the 100uf capacitors, & the analog switch ICs.
Any advice is more than welcome, I have moderate experience with console mods & soldering. But this will probably be the largest project I have taken on.
I am ordering parts to build Shank's RVL-129x BVM card. Following his BOM, I was able to find most of the parts but a couple were unavailable. I don't really know what each of the parts purpose is, and I'm pretty unfamiliar with micro component specs. So I thought I would ask here if the replacements I found are acceptable.
The first one is the 3.5mm audio jack. The BOM doesn't have a link, just a part number SJ-3524-SMT-TR. I found this part on Mouser and it looks the same to me.
The second part is this 2.2uf ceramic capacitor, part number VJ0805V225MXJTW1BC. Here is the link from the BOM:
The replacement I found has a few different specs, including dielectric & tolerance. I have no idea if these are relevant or important for my use case. I think they are the same size but the original part only specifies width, not height & length.
Everything else was in stock and available. Total order is currently ~$70 with shipping. The most expensive parts being the DIN connector, the 100uf capacitors, & the analog switch ICs.
Any advice is more than welcome, I have moderate experience with console mods & soldering. But this will probably be the largest project I have taken on.
