Question Cube game controller not working

Joined
Feb 11, 2020
Messages
84
Likes
91
Location
Thailand
Hello everyone I need help I cut the motherboard like in the picture. Almost everything works normally. There is only one problem, my controller is not working. I connected the controller at this location.Sorry for using my language. I use google to translate.
20221120_103055.jpg
GCTrim031.png
GCTrim032.png
 

Stitches

2 and a Half Dollarydoos
Staff member
.
.
Joined
Feb 5, 2017
Messages
3,776
Likes
2,982
Location
Banana Bender Land, Australia
Portables
6
Sorry, not the resistor fix, you need the controller transistors to be intact. They're near the trim line, did you hit them at all?
 
Joined
Feb 11, 2020
Messages
84
Likes
91
Location
Thailand
Sorry, not the resistor fix, you need the controller transistors to be intact. They're near the trim line, did you hit them at all?
Thank you, I will follow your advice. This is that set of transistors. If it doesn't work, I'll take it from another board and put it on.
20221121_081645.jpg
20221121_081653.jpg
 

Stitches

2 and a Half Dollarydoos
Staff member
.
.
Joined
Feb 5, 2017
Messages
3,776
Likes
2,982
Location
Banana Bender Land, Australia
Portables
6
The relocation vias for the transistors are marked in the trimming guide btw
 
Joined
Feb 11, 2020
Messages
84
Likes
91
Location
Thailand
The relocation vias for the transistors are marked in the trimming guide btw
Thank you very much for your help. Now that I can use the control unit, I fixed it by supplying 3.3 volts through a 750 ohm resistor. before entering the data line of the control unit according to the position in the figure
gc จอย.jpg
 
Top