Lemoncake's latest activity

I'll make sure to do that ASAP. I can do the relocation and power it on normally to test it right? If so, I'll try and bang it out later...

Good work so far! This will be a really cool project to open source (I’m sure you’re not the first guy who’s wanted to make a 4 layer...

I'm pretty sure that jefflongo's Wii Micro varient used a 4 layer board. it's a different size case, but might be more of what you're...

Well, looks like it’s finally time. A composite video, wireless controller and sensor bar dependent, (disc-drive required question mark...

Wait, so does this technically mean that it’s possible to create a working Wii trim that DOESN’T need RVLoader? Technically, all the...

If you want to use those points or scratch the vias near the gpu, it’s ok I was saying that you can solder direclty to the connector...

I can’t just solder the test pads on the module to the points here? (since it’s a 6-layer board)

Hello ladies and gentlemodders! We’re back with another episode of “Why You Should Always Install RVLoader On You Wii Before You Try and...

That worked like a charm! After wiring up BACK to the 12v line and hooking it up to the multimeter, I get instant boot! However...

When you wire the “BACK” pin to 12V (I don’t know if works with a lower voltage) the screen turns automatically on any of the AV inputs...

Hey! Sorry to bother you again, but I just realized I had one more question. Is there any chance you know of a way to bypass the need...

Thanks so much. That fact that it natively supports composite is a relief (may not be ideal for you veteran portablizers, but as someone...

I remember those. What you have there is a basic composite only screen. The two AV pins are your two composite inputs which the screen...

What’s up everyone? So I am currently in possession of an old car backup camera that I was planning on using as a screen for a portable...