Search results

it comes out 1.8v from the middle pin....

Yes

I put my 3.3v wire at the point drawn in red and I connected my gnd wire to a gnd location on the board. I didn't change anything apart from that.

Yes

knowing that I have kept everything, I am therefore not unsoldering anything.

then... it works, the screen lights up but the charge and discharge module turns off and no longer powers anything. (he goes to safety I think)

so I connect my 3.3v wire to the 3.3v output of the inductor? should I remove the inductor to test if it works? can my screen die?

yes, I have already seen this guide. I think I found the regulators?!? but I don't know what to do anymore. the first on the left of the image = 5v the second =3.90v the third = 3.33v the fourth = 3.90v

hello I currently have a screen card that works with a minimum voltage of 5v. So I had a question. is it possible to modify the board so that the screen can work with a lower voltage. I've never had to deal with this type of problem and I'm afraid of breaking my screen....

Es-tu sûr? Parce que lorsque le VGA Hack est sorti pour la première fois, il prenait en charge le menu système après la v1.3. https://bitbuilt.net/forums/index.php?threads/wii-native-vga-version-1-5.2176/post-29506

Hello everyone ! I currently have a problem with the VGA patch. I installed the vga patch and all Wii games work as well as some Game Cube games (some Game Cube games are not supported by my screen). The problem is that when I want to access the Wii menu system, my screen doesn't show me any...

hello I wanted to know if it was possible to use the original Wii audio amplifier for the song, knowing that I only have 5v

Is one pressure level enough or do you need two? (The connection of its buttons is 1 GND wire and another for the L/R pads of the GC+?) Sorry if my english is bad, it comes from Google Translate...

Is it correct ?

Re-bonjour, j'ai écouté vos conseils et j'ai finalement découvert que gc+ ne fonctionne pas si le bluetooth est activé. Après avoir résolu ce problème, j'en suis tombé sur un autre.... dans le menu de configuration les boutons L et R sont reconnus et quand j'appuie dessus ils affichent 255 mais...

Hello, today I encountered a new problem. I realized that not all Wii games work with GC+, no buttons work. The only game that works 100% is Mario Kart. I have activated and configured GC2wiimote for each game but it does not work. (Game Cube games work) Help.

(updated) I received my 3D parts so I'm almost finished building my console. All I'm missing are the ABXY buttons and the D-pad. I just started cutting up a dead Nintendo DS to get the buttons and I'm going to plug them into the GC+, finally I'll connect the screen control buttons.

It's cut and it works!

I don't understand...this is supposed to work, right? the button remains pressed even without the membrane.

I found a picture with the soldering points of the buttons but when I connect with GND it looks like the button is sending a signal continuously.