Search results

Thanks for the reply, I should have realized the size difference. I guess I must wait for one of the big kahunas to bestow their wisdom upon me.

I need another LCD and Driver Board. Is the screen on the BitBuilt store compatible with the GBoy? If not, can I get a link to a compatible one?

Thank you

I dropped and lost one of my battery clips. Can I get a link to where I can buy replacements?

I too had this issue with my Wii (GBoy Kit). Sadly, I do not have any fixes because I broke the Wii board when trying to troubleshoot the problem, I forgot to unplug the batteries before soldering. I am only replying to this thread because I had a consistent behavior that I would like to know...

Which probe should be on the GRND pads and which should be on the voltage pads? I am getting different measurements when switching the probes around.

I'm a little busy tonight with school work, I'll report back with the resistances tomorrow. I expected I did something that screwed it up. I it also very likely that I left a battery in while troubleshooting the controller issue. (Mentally shat myself when I had the issue --> Forgot to unplug...

I was in the process of finishing Step 16 of the GBoy Assembly Guide, as I had successfully completed every step up to that point. When I went to test my work after completing Step 16, I ran into an odd issue. The Wii would take a half second longer to boot and the controller inputs would not...

I tested after removing the unnecessary wires and still the same result. (Fan does not turn on.) - BTN still drops to 0v when the power button is pressed and held. - Continuity has been verified for GRD and BTN between the USB-C and PMS board

I measured this voltage with both probes on the PMS board. I have tried holding the button for longer, still nothing. Here are pictures of the current state of the boards.

After completing the requested steps (removing 5v, vsys, sda, scl, and chrg) and pressing the power button. . . Nothing happens.

The voltage on the BTN pads drop to 0v when the power button is pressed (for 2 seconds). I also forgot to mention what when I have the charger and batteries plugged in, I measure 0v on the CHRG pads.

Well, I can't supply images of my wiring to the Wii because I have removed everything when I assumed it was the Wii that was the problem. My current problem revolves around the fan, LED, and LCD power not working. (Sorry for the half finished initial post, I accidentally hit a keyboard...

Background Prior to my current issue, I was completing the 16th step of the guide. After wiring up the audio, my GBoy took a half second longer to boot and the controller inputs no longer worked. I decided it would be best to do a little troubleshooting before I went to the forums...

Thank You

Where do I solder the other side of the wire that connects to the 1.8v pad on the audio amp? I am assuming it goes to the PMS, but I just wanted to make sure. I am sorry if I missed it in the instructions, but I could not find it listed anywhere.

Thank you, that worked.

BBLoader version: v1.1 Description of issue: Cannot enter the Safe Menu of BBLoader. I forgot to enable VGA video on my initial installation of BBLoader, but the L+R+Z button combo during boot does nothing. Notes: USB drive formatted with guiformat (Fat32 with 32k allocation units) All...

Does the long half or the short half of the light tube get put inside the hole? The instructions state the long half should go in the hole, but I cannot fit it. The hole is not wide enough to fit the longer half's diameter. It is also nearly impossible to push on the tube with pliers. If I let...

I got it to move smoother by sanding down a small section of the bottom half of the support/post that holds the z-button. Thanks for all the suggestions!