electronics

Hello, this is my first thread; so if I seem a bit out of place...I'm still learning haha! This is a little project I call Wii Motion++ It's a Raspberry Pi running RetroPie and a 1.3 inch LCD shoved into a Wii Remote. Fully functional buttons (D-pad, 1, 2, A, B, and yes, even the power button...

Make them do-able, but super fun/ interesting haha. e.g. electronic cat armor, or a program that tracks keyboard mice and how much scrolls or clicks youve made.

hello, could someone help me? I have a ps2 fat scph50011 with motherboard gh26. I've had it for a long time, but about 5 years ago I stopped using it for lack of time. A few months ago I tried to use it again, but when I turned it on the image looked bad, so I restarted it but took out a spark...

Note before starting, I have very little knowledge of electronics, good knowledge of 3D modeling, and limited programming experience. I'm looking to design and 3D print a dock for the PS Vita that has a Raspberry Pi 3 B+ to output video. This has been done before, but I want to also add a...

Hi all! Been creeping for a while on here and decided to start a project I will have serious difficulty with as I've never done this before. I do not need to cut the Wii board at all but I still need the board to be thin. *GC memory card slots are not needed * Only one USB is needed I've read...

I'm new to this, but I think I understand it in concept. I just need some advice on how to go about doing this. Any and all advice one rewiring the buttons and joysticks is greatly appreciated!

@GingerOfOz already mentioned this a couple times but I just want to put it out there that Radio Shack is going out of business and most of their items are 50% off! https://www.radioshack.com/collections/parts-drawer Enjoy while it last!