cajohnBB
.
- Joined
- Apr 22, 2023
- Messages
- 33
- Likes
- 11
Hello, I just started working on my 1st potable, the Ashida, after sourcing what I beleive is tro be everything.
I modified the drive board by remover the inductor to power it by 3.3v. However, am not sure where
do I power a 3.3 v line to on the board. It isnt entirely clear to me looking at the image 4Layer has noted
on it.
Any help would be appreciate.
I modified the drive board by remover the inductor to power it by 3.3v. However, am not sure where
do I power a 3.3 v line to on the board. It isnt entirely clear to me looking at the image 4Layer has noted
on it.
Any help would be appreciate.
