- Joined
- Sep 30, 2021
- Messages
- 11
- Likes
- 1
Hello everyone,
I am new to the portiblizing community and have just started my n64 portable using the n64 advance trim guide.
I am having difficulties getting it started, im sorry if some of the photos attached are horrifying compared to the amazing stuff I've seen here, but I've tried to follow the guides to the best of my understanding.
I relocated the PIF by hot gluing it to a bread board, I soldered magnet wire to the locations indicated on the guide and ran them to individual solder points, then glued them in place on the bottom and soldered glob them on top. I then ran magnet wire to the locations as indicated on the guide. All locations indicated on the guide show continuity from the different chips and points on pin to the PIF it self.
The video was soldered to the point indicated on the guide.
I am at a loss at this point. The only part in the guide I did not understand was the connection of C2 and C3 to the 3.3v and ground. Am I supposed just connect 2 .1uf capacitors to any ground and 3.3v?
If anyone notices where I messed up, please feel free to let me know.
Thank you
I am new to the portiblizing community and have just started my n64 portable using the n64 advance trim guide.
I am having difficulties getting it started, im sorry if some of the photos attached are horrifying compared to the amazing stuff I've seen here, but I've tried to follow the guides to the best of my understanding.
I relocated the PIF by hot gluing it to a bread board, I soldered magnet wire to the locations indicated on the guide and ran them to individual solder points, then glued them in place on the bottom and soldered glob them on top. I then ran magnet wire to the locations as indicated on the guide. All locations indicated on the guide show continuity from the different chips and points on pin to the PIF it self.
The video was soldered to the point indicated on the guide.
I am at a loss at this point. The only part in the guide I did not understand was the connection of C2 and C3 to the 3.3v and ground. Am I supposed just connect 2 .1uf capacitors to any ground and 3.3v?
If anyone notices where I messed up, please feel free to let me know.
Thank you
Attachments
-
1.5 MB Views: 203
-
3.1 MB Views: 192
-
1.4 MB Views: 183
-
1.3 MB Views: 175
-
3.3 MB Views: 171
-
3.3 MB Views: 166