J4V0's latest activity

ok, well, I will continue investigating and testing to see if I can make it work, thank you very much for the help

I already checked the lines around 3.3v and they all seem fine, what I noticed is that when measuring the 3.3v line with the u10 ground...

Hello, notice that and check the continuity and yes it has continuity, and I measured around to see if it was shorted and no nearby...

I haven't cut out the board yet, and these are the best photos I took of u10, you guys need photos of the entire board?

Hello everyone, I hope you are well, I am starting in this world of wii trimming and I have a problem repositioning the u10, I did...

What if we had a few different threads that were FAQs for specific subjects, and if your question wasn't there in the thread, you ask in...

I guess it's time. I stopped building Wiiboy Colors because I did not enjoy assembling the USB-C and old PMS boards needed to build...

As promised here are pictures of the inside finished : And after long months of research, learning, development and design Let me...

6 - Assembly and first tests : For the assembly, I started with the upper part by placing the screen then I double-sided tape the...

3 - CAO Time : Usually I use Solidworks but this time I use Fusion 360 because of the custom NDS lite pad PCBs I made in Eagle, the...

Oh thanks, very good price i'm going to watch that. 2 - Wii trim : My WII is a black WII with RVL-CPU-50 board, it is a 4 layer...

I started assembling the bottom half and quickly learned that the PMS PD 3 is slightly larger than it's predecessor, causing the fan to...

As mentioned in the project thread, I've edited Wesk's files to use a cheap Arduino Micro SD module rather than chopping up an SD Micro...

Preface The Definitive Wii U Trimming Guide only supports WUP-50 Wii U motherboards. WUP-50 motherboards consume much less power than...