I got a new Wii, trimmed it, and wired it up. Still not booting. I have a 5v power source bumped down to their allocated values and I don’t know what I am doing wrong. I am starting to loose hope in this project. Does anyone have advice/ corrections to what I did? Also, is the boot dependent on...
I got a new Wii, trimmed it, and wired it up. Still not booting. I have a 5v power source bumped down to their allocated values and I don’t know what I am doing wrong. I am starting to loose hope in this project. Does anyone have advice/ corrections to what I did? Also, is the boot dependent on...
I am new to console modding and I have a custom voltage regulator. (See image below). do I need multiple regulators to build my portable? Also, I have a six layer board if that adds any information...
I am new to modding and I was following the trim guide and got to the point where I am relocating the U10 and I flipped over my board to realize that it is completely different from the guides. The parts are in different locations and I am not sure how to continue other than buy another wii...
Where did you get your voltage regulators? I looked at the guide but when I went online, there were dozens of different regulators with the same name but different values.
how many bolts are going into your wii? You have a regular micro usb going in so I figured it was 5 volts, but a lot of the screens I have seen require at least 9 volts.