Recent content by subierekt

Oh shit. In for the lulz. This is going to be wild.

I’d have to figure out how to source the acrylic, but I’ll likely have some extra boards regardless. You’d be in your own for the BOM though

Done :)

Have a few people already interested, but figured id put it here as well. I approximate they'll be around $20 each or so plus shipping to you. Once we get a final number ill submit a quote and we will get to gettin. I previously submitted a quote for 2 and it was about $66 after shipping...

It’s not a via, you scratch the solder mask off and there’s ground plane underneath. There is a via underneath the component you solder, you need to make sure it doesn’t bridge

Fixed maybe?

Too slow :mrgreen:

https://a.co/d/74B5Vde use this for a guide for the jumpers maybe

So theoretically could the 5v reg on the short stack board handle this? So you could really only have 5v/gnd and the data lines if using this in short stack. Not that id really care about undervolting in a non portable like it, just using it as an example.

This is cool as fudge

Pears in shambles

Yeah it was a joke not a serious suggestion lol, tongue in cheek since botw is on switch and that’s a already portable.

Do it with a Wii U portable! Just imagine, portable breath of the wild! It’ll be amazing! You could literally play BOTW anywhere with just a small tablet like device! Truly living in the future.

Gunnar stated on the discord that it should be a few weeks and they will be back in stock. Just wait for the correct part, it solders directly to the ashida controller board easily.