Search results

ok, well, I will continue investigating and testing to see if I can make it work, thank you very much for the help

I already checked the lines around 3.3v and they all seem fine, what I noticed is that when measuring the 3.3v line with the u10 ground lines to check if it is shorted it gives me a resistance of 386.6 ohm, that's it normal?

Hello, notice that and check the continuity and yes it has continuity, and I measured around to see if it was shorted and no nearby point has continuity

I haven't cut out the board yet, and these are the best photos I took of u10, you guys need photos of the entire board?

Hello everyone, I hope you are well, I am starting in this world of wii trimming and I have a problem repositioning the u10, I did everything as mentioned in the guide and when I turn on the wii it sends me a video for 5 seconds and then the The image is distorted and you only see lines on the...