resistance

First timer here. I'm working on a Wii-in-GameCube project based on Nold's Miicro and I just trimmed my 6-layer board but even after 2+ hours of sanding my 1V is still shorted to ground. I'm hoping someone can help me troubleshoot this and figure out how to find and fix the short. All other...

So I followed the Nold's Wii trim resistances "guide" and verified that all my resistances were the same or very close, and they were. Though after soldering everything up to test the motherboard booting the fan connected to my PMS Lite would spin for a few seconds and everything shut off. Now...

What's up, figured I'd start a worklog for this project. It's probably going to be a long term project but I had some questions so I guess it makes sense to put them in a worklog. Feel free to move this post around somewhere if it's better suited elsewhere. I've made several Pi portables in...

So I'm curious, what does everyone do for resistor values regarding the pth08080w regulators? They require some pretty oddly specific resistance to get the needed voltage for wiis so I haven't been able to find singular resistors with the correct values. I haven't actually strung them together...