Hello as a dutch student we have a final paper to finish pre-university education and i am allowed to make a WII handheld for a final paper, so i'm stoked to do it, but after reading tons on this website i still have some spots i'm clueless about, like wiring the display, but that will come later. First i wanted to make a parts list of everything that i need, so far i got this from all the guides:
Nintendo Wii, 4 of 6 layer board, currently got a 6 layer board wii at home, but unsure if getting 4 layer is worth is as people say making a 6 layer handheld is easier?
- Powerport
- Switch
- Red changing board
- 4x pth 08080w or Wii Power Management System (but this seems hella expensive to ship to EU)
- Soldering iron (got one)
- Voltmeter (got one)
- 4x 18650 battery
- 5 inch 480p screen? unsure if VGA mod is doable as a beginner so not sure which
- 35x35x7mm fan + heatsink
- pam8803 amp + 5x 20mm Round Mylar Speaker 1W 8Ohm
- Squishy tacs x200
- Fake gamecube controller to tear down
- GC+ pcb board ( not sure how difficult it is without it currently because they are out of stock )
- Flash drive
- 26 gauge (for Voltage)
- 22 gauge (for Ground)
- 38 gauge (magnet wire)