Solved LMAO trim not working

[Nicholas298]

This trim worked when I tested it a week ago, slapped it into my project and I can’t get it to boot. I’ve tried reheating the NAND connections, checked continuity on the NAND legs, and check voltages and it all seem ok, do y’all see something I don’t??

 

[Wesk]

I'd check the PMS voltages while the system is on and see if anything is pulling lower than it should.

 

[Nicholas298]

Also 3.3v measures 16.3k Ohm?? Don’t know if that’s normal

 

[Wesk]

Also 3.3v measures 16.3k Ohm?? Don’t know if that’s normal

That's fine

 

[Nicholas298]

All PMS voltages are on the dot or a lil above

 

[Nicholas298]

Fixed it, one of the nand legs was not on all the way smh, thanks anyway Wesk!