Wittkoss
.
- Joined
- May 16, 2021
- Messages
- 2
- Likes
- 6
Hello everyone, want to show my portable. It was built last january after a month of designing and a few months of procrastinantion.
Obviously, its design was inspired by Gman's early PS2 The dimentions are 205x112x36 mm.
It powered by 4x18650 samsung batteries through chinese red CPB. The screen is 5inch TFT from Ali wired as VGA and composite. For audio I used PAM8403 for speakers and MAX4410 for headphones.
Controller implemented by salvaging old original dualshock, for rumble two small 3V DC motors were used. I used buttons caps and cross from Ali over grey-rubber buttons - up to me it feels like the original ones. Shoulders were printed and placed over tactile switches. Analogs are the switch ones. At first I placed the analogs just below the cross/buttons, but my thumbs hurts, so I tried to place it closer to screen. Now everything is ok
Isos are loaded via SMB realized by means of OrangePi Nano. For some reason I added memorycard port lol.
Sure it looks messy inside, but I satisfied with the results.
My next goal is to make the one with huge 8inch screen with a lot of custom PCB
Obviously, its design was inspired by Gman's early PS2 The dimentions are 205x112x36 mm.
It powered by 4x18650 samsung batteries through chinese red CPB. The screen is 5inch TFT from Ali wired as VGA and composite. For audio I used PAM8403 for speakers and MAX4410 for headphones.
Controller implemented by salvaging old original dualshock, for rumble two small 3V DC motors were used. I used buttons caps and cross from Ali over grey-rubber buttons - up to me it feels like the original ones. Shoulders were printed and placed over tactile switches. Analogs are the switch ones. At first I placed the analogs just below the cross/buttons, but my thumbs hurts, so I tried to place it closer to screen. Now everything is ok
Isos are loaded via SMB realized by means of OrangePi Nano. For some reason I added memorycard port lol.
Sure it looks messy inside, but I satisfied with the results.
My next goal is to make the one with huge 8inch screen with a lot of custom PCB