I'm trying to do the trim but got stuck on the first step, the wifi relocation. Butchered the first wifi module by ripping off some contact points, second also ripped a point but I was able to solder to a via instead. Then when I connected it and it didn't work, so I tried shortening a wire and a wire popped of from the module, didn't secure them well enough, ugh. Desoldered the module again.
Since then the wifi modules don't work in the wifi slot either. I have hbc installed and priiloader to boot straight into hbc. The wifi icon is flashing and reset to enter priiloader doesn't work, which is the same as with no wifi module. Has anyone else experienced this?
I made a third try to solder to the resistor array, turned out cleaner this time but it still doesn't work. Data wires are all 4 cm.
Any idea what could be wrong?