Hi folks & welcome to the worklog of my last n64p.
The Nintendo 64 always has been one of my favorite consoles of all time. Most likely because it came out when i was a kid and i remember playing it A LOT. Anyways, after disassembling my first n64p very quickly and quite a few dead n64's by now, i left my last working n64 trim lying around a long time.
But it should rise again! It's 90deg. bended card slot, combined with the VGA power of the N64 advanced board and the compatibility of a everdrive64 where calling me to build the 'ultimate' n64p!
Long story short / specs:
- Trimmed n64 + cardslot 90deg. bending
- Memory pak, also 90deg. bended
- N64 Advanced powered VGA output (480p)
- 5" 4:3 VGA Screen (640x480)
- Everdrive64, internalized
- Custom Switch Buttons (thx madmorda)
- 2x 18650 2500mAh
- possibly classic red board = 2s1p
- or PMS = 1s2p ?!
- audio, controls n' shit
The case design is based on the woodii, since the n64 board fit into one of it's proto prints just perfect. I reduced the width quite a bit. Current outside dimensions are: 177x102x34mm
The first prototypes looked promising i hope i can print the final case soon.
Currently i'm trying to figure out how to keep my smolboi chill. considering the space that's left inside the case, easier said then done.. thanks to the bended pcb & expansion slot,
At least video is crisp af! more pics soon.
so long.
The Nintendo 64 always has been one of my favorite consoles of all time. Most likely because it came out when i was a kid and i remember playing it A LOT. Anyways, after disassembling my first n64p very quickly and quite a few dead n64's by now, i left my last working n64 trim lying around a long time.
But it should rise again! It's 90deg. bended card slot, combined with the VGA power of the N64 advanced board and the compatibility of a everdrive64 where calling me to build the 'ultimate' n64p!
Long story short / specs:
- Trimmed n64 + cardslot 90deg. bending
- Memory pak, also 90deg. bended
- N64 Advanced powered VGA output (480p)
- 5" 4:3 VGA Screen (640x480)
- Everdrive64, internalized
- Custom Switch Buttons (thx madmorda)
- 2x 18650 2500mAh
- possibly classic red board = 2s1p
- or PMS = 1s2p ?!
- audio, controls n' shit
The case design is based on the woodii, since the n64 board fit into one of it's proto prints just perfect. I reduced the width quite a bit. Current outside dimensions are: 177x102x34mm
The first prototypes looked promising i hope i can print the final case soon.
Currently i'm trying to figure out how to keep my smolboi chill. considering the space that's left inside the case, easier said then done.. thanks to the bended pcb & expansion slot,
At least video is crisp af! more pics soon.
so long.