design

I need to figure this out for a non-console related project, I thought I'd try asking this here. In essence, I need to make a circuit physically destroy itself on command, preferably only a cheap component so that it could be quickly reset by replacing it (the circuit will be on a breadboard)...

For my Ashida I'm making, my girlfriend will be helping me paint the case. So far, our idea is to cover it with a light blue spray paint and then put a design on the middle of the bottom half. For the light blue I've decided to use testors or tamiya (I haven't decided so if anyone has...

This model is to scale and can be used for whatever it might help you with! The measurements should all be good as I cross-referenced many diagrams, and I measured stuff myself as well.

It's possible and not too terribly difficult to add multi color designs to cases or other 3D prints. This guide shows how this is done using Fusion 360 and Cura, but other modeling and slicing programs should have similar enough features to allow this. Special thanks to @nobble for getting me...

I made some brackets to hold two tact switches together for double tact modding L and R buttons. There are two versions so far: the regular bracket, and the same thing only with a flat base on one side for mounting. Both are included in the .zip, as well as the STLs. This way you don't have to...