I want to build a laptop that uses external controllers, but I want the ability to also plug it into a TV with a sensor bar as well. I plan on using RVL-PMS-2 if/when it's back in stock, but I'd like to know where exactly I should trim the board to keep all the ports except for the SD slot. I would like WIFI but can survive without it, but I will still need the Bluetooth (of course I shouldn't have much issue just relocating that). I mainly just need to know how close to the edge of the board can I cut while not damaging the traces to the Gamecube Controller ports.
edit: I somehow managed to just forget to type a few words
edit 2: I also noticed that the RVL-PMS-2 doesn't have any 12v output. Will my sensor bar port work or will it not have enough power? I'd test it myself but I don't have necessary parts yet.
edit: I somehow managed to just forget to type a few words
edit 2: I also noticed that the RVL-PMS-2 doesn't have any 12v output. Will my sensor bar port work or will it not have enough power? I'd test it myself but I don't have necessary parts yet.
Last edited: