ZMan28
.
- Joined
- Sep 10, 2017
- Messages
- 10
- Likes
- 0
I just tested my recently trimmed CPU-40 board with my multimeter and all the readings seem ok except for any involving 3.3V where the reading jumps all over the place. I noticed a little spot where the Dremel jumped just below U7 which seems to be right above one of the 3.3V traces. I am thinking it could have short here, but I don't know if I should cut some of that section out or if that even is the problem. The only other thing I noticed is that when the LDO was removed one of the contacts pealed off with it.
Attachments
-
2 MB Views: 35
-
2.2 MB Views: 36
-
395.9 KB Views: 33
-
37 KB Views: 36