PiR8_BTY
.
- Joined
- Apr 12, 2020
- Messages
- 131
- Likes
- 260
Hey Folks,
Thought I would be the first to do the honors of posting my g-boy worklog. I got the kit last night and continued to burn the midnight oil to get as much done possible (all the while taking it slow and methodical). Overall so very very pleased with the kit and luckily I got the Software portablizemii to work after messing up one wii console with loading the incorrect ios to the NAND.
Things of note. Correct me if im wrong, but the joycons did not sit flush with the pre-drilled hole mounts. There was a little bit of an overhang and when you torque the joycon brace, it begins to warp the plastic brace without shims. Also, this was the only circumstance I ran into where the 2x4 screws seems a bit short for the job.
Also, due to this being a 3D print obviously need to do a little light sanding for controller buttons to feel normal. Nothing I didnt expect though. In case of my DS lite buttons, it was easier to shave off a little plastic material off the buttons vs doing it to the case itself less to remove hanging artifacts.
Thought I would be the first to do the honors of posting my g-boy worklog. I got the kit last night and continued to burn the midnight oil to get as much done possible (all the while taking it slow and methodical). Overall so very very pleased with the kit and luckily I got the Software portablizemii to work after messing up one wii console with loading the incorrect ios to the NAND.
Things of note. Correct me if im wrong, but the joycons did not sit flush with the pre-drilled hole mounts. There was a little bit of an overhang and when you torque the joycon brace, it begins to warp the plastic brace without shims. Also, this was the only circumstance I ran into where the 2x4 screws seems a bit short for the job.
Also, due to this being a 3D print obviously need to do a little light sanding for controller buttons to feel normal. Nothing I didnt expect though. In case of my DS lite buttons, it was easier to shave off a little plastic material off the buttons vs doing it to the case itself less to remove hanging artifacts.
Last edited: